I am stuck with 1024x768. Display comes up as a laptop. It's a Philips 17" I have no composition, 2D and fuzzy lines going up the screen.

I used the software centre to install the ATi X.Org binary driver. Useless! It loads Catalyst. If I click on Catalyst Control Centre, I get:

There was a problem initializing Catalyst Control Center Linux edition. It could be caused by the following.

No AMD graphics driver is installed, or the AMD driver is not functioning properly. Please install the AMD driver appropriate for you AMD hardware, or configure using aticonfig.

There was a problem initializing Catalyst Control Center Linux edition. It could be caused by the following.

No AMD graphics driver is installed, or the AMD driver is not functioning properly. Please install the AMD driver appropriate for you AMD hardware, or configure using aticonfig.

sudo lshw -c video gives:

 *-display UNCLAIMED description: VGA compatible controller product: RS880 [Radeon HD 4200] vendor: Hynix Semiconductor (Hyundai Electronics) physical id: 5 bus info: pci@0000:01:05.0 version: 00 width: 32 bits clock: 33MHz capabilities: pm msi vga_controller bus_master cap_list configuration: latency=0 resources: memory:e0000000-efffffff ioport:1100(size=256) memory:f0100000-f010ffff memory:f0000000-f00fffff

If I do it in terminal, it says missing dependancies and crashes..

I though I hadn't installed it, but:

fglrx is already the newest version.

fglrx-amdcccle is already the newest version.

fglrx-amdcccle set to manually installed

doing:sudo aticonfig --initial

aticonfig: No supported adapters detected

It's driving me mad!

I just want my 1280 back and Docky not complaining about compositing all the time.

1

1 Answer

Unfortunately your card (Radeon HD 4200) is too old for the fglrx driver available in the ubuntu repositories to work.
You can try and install the legacy drivers from the AMD website:
but note that these only work up to linux kernel 3.4.x !
So if the output of the terminal command uname -r shows a number higher than 3.4.x you cannot use that one.
In that case you need to uninstall the fglrx and amdcccle drivers that you installed by typing
sudo apt-get purge fglrx amdcccle and then install the old open-source drivers again.
sudo apt-get install --reinstall xserver-xorg-video-radeon

2

Your Answer

Sign up or log in

Sign up using Google Sign up using Facebook Sign up using Email and Password Submit

Post as a guest

Post Your Answer Discard

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy